Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
How do I adjust my ezgo carburetor?
2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.
How do I stop my golf cart from backfiring?
Start by carefully removing the drive belt with the engine off and then tweaking the adjustment screw as the engine is running. Adjust the screw until the engine is running as smoothly as possible. Now, you can fully tighten the screw, turn off the engine, and replace the drive belt to start your cart up again.
Why does my golf cart only run with the choke on?
4 Answers. Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.
Why does my golf cart keeps backfiring?
In almost all cases, whether it is a 2 cycle or 4 cycle engine, golf cart backfiring is caused by the accelerator cable being out of adjustment at the throttle plate of the carburetor. … With the ignition key in the OFF position and the seat completely removed, press the accelerator pedal down.
How can I make my ezgo gas golf cart faster?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.
How do you adjust the governor on a EZ GO TXT gas golf cart?
How to Adjust the Governor on a Gas E-Z-Go Golf Cart
- Locate the governor arm mounted on top of the rear axle case underneath the cart. …
- Loosen the adjusting locknut on the end of the governor spring. …
- Retighten the adjusting locknut.
How do I know if my golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
How do you start a choke on a gas golf cart?
To operate your choke, first locate it and determine if you have a button or cable style. Next, turn your key ON. Depending on your vehicle, either push the choke button or pull the choke cable while pressing the accelerator pedal.
How do you adjust the carburetor on a Club Car golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
How does a Yamaha golf cart fuel pump work?
The fuel pump has several nozzles on it to accept the vacuum line, and both the Fuel In and Fuel Out lines. Inside the pump, there are several diaphragms which use the pulsing action created by the vacuum of the crankcase pressure to draw fuel from the storage tank and push it onward to the carburetor of the golf cart.